Sienne Jeanneau International 50 Instrukcja Obsługi

Jeanneau International 50 SIENNE OPERATION MANUAL

9 The 110 v can be used when connected to the shore power. The thermostat is located on the galley wall behind the refrigerators. The right side lo

10 AUTO PILOT The Autohelm Auto Pilot display is located on the instrument panel. To activate, switch the DC breaker (Auto Pilot) to ON. Refer to

11 led back to the two large cockpit winches. Adjust fairleads forward in heavy air, aft in light wind. The battened Mainsail is raised and lowe

12 the tow line from becoming entangled around the prop. Secure the tow line to a deck cleat only. Use extreme caution when mounting the outboard o

13 Bilge Pumps Christelle is equipped with an automatic bilge pump. The switch must remain on at all times. A second, manually activated bilge pum

14 Location of thru hulls

15 Location of fills and pump outs

1 Welcome Aboard! We are happy that you have chosen Ship Harbor Yacht Charters and the vessel, Sienne, for your vacation. We hope you enjoy yo

2 TABLE OF CONTENTS Boat Operation Page Engine Inspection 3 Start-Up Shut

3 BOAT OPERATION Engine Inspection Remember your “WOBBS” every morning. (Water (Coolant), Oil, Bilges (Inspect and Pump-out), Belts, and Sea Str

4 Shut Down Before shutting the engine down, let it cool for 5 minutes at idle and transmission in neutral. Turn off the engine by lifting the &quo

5 attention to the vent that it does not spill fuel into the water. Top-off carefully, catching any spillage with your sorb pad. Check your gauge

6 When connected to shore power, the inverter acts as a battery charger for the 12 volt house batteries. Should you detect the inverter failing to c

7 paper towels, napkins, sanitary products, household T.P., or food into marine heads. Use only marine T.P. provided by SHYC. To use the toilet, mo

8 decks. When filling the tank, avoid flushing debris into the fill opening. Do not fill water and diesel at the same time! A manifold to switch t